Ever wanted to drop a Polarstar F2 into your Wolverine MTW? This is a 100% drop in solution to put an F2 or other engines into an MTW body.
These kits fits any Hopup, any generation, or most models. The F2 and SMP will not fit in the Article 1 due to it needing to be installed upside down, but the Jack and Reaper will.
Uses a standard M4 Nozzle!
Installation is simple, just put the nozzle spacer on the engine, rotate the engine so that the installation pin holes line up and so that the engine retention clip can slide into place. The electronics are plug and play or there is an option to DIY the electronics, this can be perfect to save a few dollars by using your existing wiring harness.
F2: Includes the 3D printed engine retention clip, 3D printed nozzle spacer, 3D printed trigger board, microswitch, and wiring (wiring not included in the DIY wiring option).
Jack: Includes the engine mount and hopup spacer. Just use the stock Wolverine Trigger board instead of Polarstar Electronics.
SMP: Includes a modified feed tray and nozzle spacer, the standard Wolverine Trigger board can be used. The only modifications needed are light sanding on the rear of the engine so that it slides in upside down.
Reaper: Includes the engine mount and hopup spacer (different mounting from the Jack). Just use the stock Wolverine Trigger board or our Reaper EM Trigger Board.
